Table of Contents
Advertisement
Airstrike
Installing the Lamp
The Showtec Airstrike uses the 5R (ordercode 80988 / 81013) reflectorbulb as manufactured by all popular
manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure:
01) Loosen the 4 screws on the back of the housing.
02) Gently remove the small metal housing.
03) Read lamp instructions. Do not touch the lamp bulb glass. (See Figure 3.). Oil on hands shortens the
lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing
alcohol.).
04) Insert the lamp into the lamp socket.
05) Put the lamp cover back and fasten the screws snugly.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 43158
8
Fig. 03
Advertisement
Table of Contents
