Page 2
For more information: iwant@showtec.info You can get some of the best quality, best priced products on the market from Showtec. So next time, turn to Showtec for more great lighting equipment. Always get the best -- with Showtec ! Thank you!
WARNING CAUTION! Keep this device away from rain and moisture! FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! SAFETY INSTRUCTIONS Every person involved with the installation, operation and maintenance of this device has to: be qualified follow the instructions of this manual CAUTION! Be careful with your operations.
The LED Bar DMX can be placed on a flat stage floor or mounted to any kind of truss by a clamp. Improper installation can cause serious damage to people and property !
Description of the device Features LED Bar DMX is a LED system from Showtec. • Sound-controlled via built-in microphone • 3 Modes: Stand-alone, DMX-controlled or Sound-controlled • 4 Channels (R, G, B and Dimmer for entire deivce) • 20 Channels (R, G, B and Dimmer for each individual section, device has 5 sections) NOTE: Knowledge of DMX is required to fully utilize this unit.
Installation Remove all packing materials from the LED Bar DMX. Check that all foam and plastic padding is removed. Connect all cables. Do not supply power before the whole system is set up and connected properly. Always disconnect from electric mains power supply before cleaning or servicing. Damages caused by non-observance are not subject to warranty.
Dimmer (0-255) Etc….etc. The LED Bar DMX’s built-in controller will automatically detect the presence of a DMX signal. IF a DMX signal is present, the blue LED display will blink. In order to receive a DMX signal, the built-in controller must be attached to a DMX controller by a 3-pin DMX cable and the DMX controller must be turned on.
3. If all of the above appears to be O.K., plug the unit in again. 4. If you are unable to determine the cause of the problem, do not open the LED Bar DMX, as this may damage the unit and the warranty will become void.
Product Specification Model: Showtec LED Bar DMX Voltage : AC 230V-50Hz (CE) Power: 40W Fuse: 250V / T1A Audio trigger: Built-in Mic DMX Input : 3-pin XLR Male connector DMX Output : 3-pin XLR Female connector Dimensions : 1505 x 200 x 100 mm (LxWxH) Weight : 9,4 kg Design and product specifications are subject to change without prior notice.