Installing The Lamp - SHOWTEC Stage Blinder 4 DMX V2 Manual

Stage Blinder 4 DMX

Installing the Lamp

The Stage Blinder 4 DMX uses the Par 36 G53 Screw MFL GE 120V/650W (DWE) bulb (ordercode 80117) as
manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with higher wattage! Lamps with higher wattage generate temperatures the device
was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure
01) Pull the 2 fixation screws on the front of the lamp housing (Fig. 03).
02) Gently remove the metal lamp cover (Fig. 04).
03) Read lamp instructions. Do not touch the lamp bulb glass. Gently remove the lamp from its socket.
04) Unscrew the 2 cables on the back of the lamp and remove the lamp. Oil on hands shortens the lamp
life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free towel and rubbing alcohol.)
05) Take the new lamp out of the box (Fig. 05).
06) Take the 2 cables and by using the screws, fit them to the back of the lamp. Place the lamp in the
housing (Fig. 06).
07) Place the metal lamp housing back and fasten the 2 fixation screws.
Ordercode: 30772
Fig. 03
Fig. 05
8
Fig. 04
Fig. 06