Table of Contents
Advertisement
StageBeam 300/500W Fresnel
Installation
Remove all packing materials from the StageBeam 300/500W Fresnel. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Installing the lamp
The Showtec StageBeam Fresnel 300/500W uses the GY9.5 Osram lamp, 300W (ordercode: 80703O) and
the GY9.5 Osram lamp, 500W (ordercode: 80704O).
Use only the appropriate lamp for your unit. Note that product versions, that use other lamps, may be
offered in the future. Check your product specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps of higher wattage!
Lamps of higher wattage generate temperatures which the device was not designed for.
Damages caused by non-observance are not subject to warranty.
01) Disconnect the StageBeam from power before installing the lamp. Allow 15 minutes to cool down
the lamp.
02) Loosen the locking screw from the color frame at the top view of the fixture.
03) Remove the locking screw at the back.
04) Remove the top cover.
05) Remove the lamp from the box and hold it by the base. Read lamp instructions. Do not touch the
lamp bulb glass. Oil on hands shortens the lamp's lifespan. If you touch the bulb glass, wipe it off with
a clean, lint free towel and rubbing alcohol.
06) Insert the lamp and fit it firmly within the lamp brackets.
07) Replace the top cover and the locking screw at the back.
08) Tighten the locking screw at the top view of the fixture.
Ordercode: 30530
8
Fig. 02
Advertisement
Table of Contents
