Puller
10.8 Disk brake pressure setting
Proper setting
The spring is to be pressed to the value of 17 mm.
Pic. 49: Disk brake pressure setting
(1) - Fastening screws
(2) - Setting ring
1. Loosen two fastening screws (1) of the setting ring (2).
2. The setting ring should be able to freely move on the shaft.
3. Press the spring (3) with the setting ring (2) to the brake disc (4) to the
4. Tighten two fastening screws (1).
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
value of 7 mm.
17 mm
(3) - Spring
(4) - Brake disc
①
②
③
④
61