Thread trimming
9.2 Driver
Proper setting
If the driver (4) touches the casing (5), the thread-pulling knife (2)
should have the distance (A) = 0.5 to 1 mm on its left edge opposite
the fishplate (1).
Pic. 37: Driver
①
②
(1) - Fishplate
(2) - Thread-pulling knife
(3) - Screw
1. Tilt the machine ( p. 12).
2. Loosen the screw (3).
3. Shift the trimming knife (2) as per proper setting.
4. Place the driver (4) on touch with casing (5).
5. Tighten the screw (3).
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
A
①
②
(4) - Driver
(5) - Casing
⑤
④
③
49