Thread Trimming; Trimming Pressure Between Knives - Dürkopp Adler 52Xi Service Instructions Manual

9

9.1 Trimming pressure between knives

Proper setting
The counter knife pressure should be as small as possible, however, there
is a safe and clean thread trimming. The knives should be on touch within
the last part of the trimming knife path only.
Pic. 36: Trimming pressure between knives
(1) - Screws
(2) - Plate
(3) - Screw
1. Loosen the screws (1) of the trimming carrier plate (2).
2. Remove the plate (2).
3. Shift out the thread-pulling knife (5) from basic position and insert the
4. Set with the screw (3) the counter knife pressure according to proper
5. Mount the plate (2) back again so that the lever (4) is in the recess of
48

Thread trimming

WARNING
Risk of injury from moving parts!
Crushing possible.
Switch off the machine before checking and setting .
①
②
trimming thread to the hook of knife.
setting and check perfect thread trimming.
thread-pulling knife (5).
⑤
④
③
(4) - Lever
(5) - Thread-pulling knife
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
Thread trimming