Distance From Puller To Needle - Dürkopp Adler 52Xi Service Instructions Manual

Puller

10.2 Distance from puller to needle

Proper setting
The distance between the feeding wheel center and the needle axis is
29 mm.
Important
If the distance is set anew, then the upper as well as bottom end position
also must be set anew! ( p. 54)
Pic. 41: Distance from puller to needle
(1) - Screw
1. Loosen the screw (1).
2. Turn the frame (2) on the axis.
 The distance between the feeding wheel center and the needle axis
3. Tighten the screw (1).
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
29 mm
must be 29 mm.
①
②
(2) - Frame
53