Table of Contents
Advertisement
Table 13. Configuring the Master Switch for a Stack Trunk of Multi-Gigabit Copper Ports - Part II
Step
Steps 3 and 4 remove the default SFP+ S1 and S2 ports from the trunk on the provisioned
member switches that you added in step 2, with the NO STACKPORT command.
3
Enter the port Interface modes of the SFP+ S1 and S2 ports in the provisioned
member switches on the master switch. (Refer to "Specifying Ports in the Command
Line Interface" on page 58.) This example assumes provisioned switches with IDs 2,
3, and 4 are GS970EMX/20, GS970EMX/28, and GS970EMX/52 Switches,
respectively:
awplus(config)# interface port4.0.19-4.0.20,port2.0.27-2.0.28,
port2.0.51-2.0.52
4
Enter the NO STACKPORT command to remove the SFP+ S1 and S2 ports from the
stack trunk and designate them as regular Ethernet ports:
awplus(config-if)# no stackport
% Save the config and restart the system for this change to take
effect.
Steps 5 and 6 use the STACKPORT command to designate the Multi-Gigabit copper ports as
the stack trunk on the provisioned member switches on the master switch.
5
Enter the Interface modes of the Multi-Gigabit copper ports on the provisioned
member switches in the master switch. This example assumes provisioned switches
with IDs 2, 3, and 4 are GS970EMX/20, GS970EMX/28, and GS970EMX/52
Switches, respectively:
awplus(config)# port2.0.17-2.0.18,port3.0.25-3.0.26,port4.0.49-
4.0.50
6
Designate the ports as the stack trunk with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
The remaining steps save your changes on the master switch and reboot it.
7
Enter the EXIT command twice to return to the Privileged Exec mode.
awplus(config-if)# exit
awplus(config)# exit
8
Enter the WRITE command to save your changes.
awplus# write
Building configuration ...
[OK]
CentreCOM GS970EMX Series Installation Guide for Virtual Chassis Stacking
Description and Command
137
Advertisement
Table of Contents
