Programming - tams elektronik FD-R Basic.3 Manual

FD-R Basic.3

7. Programming

Programming with DCC central units
You can program the configuration variables (CV) of the decoder from
the digital central unit, you can use main track programming as well.
See the chapter in the manual of your central unit where the byte wise
programming of configuration variables (CVs) (Direct programming)
and main track programming (POM) are explained.
Register programming is not supported by the decoder. With DCC
central units that allow only register-programming it is not possible to
program the FD-R Basic.3.
Programming with Motorola central units
In Motorola format the settings are saved in registers. The registers
have the same numbers as the configuration variables (CVs) for the
DCC format.
Please note: If you use a central unit for both DCC and Motorola format
it is recommended to program the decoder in the DCC format. After
having finished programming the decoder it is possible to control it in
Motorola format as well.
Please note: You should connect a lamp or a LED to at least F0f or F0r
before starting to program the decoder with a Motorola central unit, as
the decoder shows the status of the programming by flashing the
lighting connected to these outputs. The flashing frequency shows,
which input the decoder expects:
Slow flashing
Number of the register to be
programmed
Fast flashing
Value of the register to be
programmed
English
Page 27