Function Outputs - tams elektronik FD-R Basic.3 Manual

FD-R Basic.3

if the decoder suddenly switches to analogue mode in digital
operation (e.g. as a result of interference voltages whose cause is
difficult to localise);

if a value for the Packet Time Out is programmed to perform a
forced stop in case of track voltage failure or shutdown.
Switching the function outputs
Switching the function outputs on or off is not possible in analogue
mode. The outputs can be programmed with the digital central unit so
that they are either switched on or off in analogue mode. The effects
set for the outputs are active in analogue mode as well.
Outputs that are switched depending on the direction are switched on
or off in analogue mode according to the direction of travel. When
operated in analogue d.c. layouts this applies only to lamps or accessories
where the return conductor is connected to the decoder´s common return
conductor for all function outputs.

4.3. Function outputs

The decoder has four function outputs with a maximum current of 300
mA each (F0f, F0r) or 100 mA each (AUX1, AUX2) for the connection of
additional accessories (e.g. lighting, smoke generator, electrical
coupling). Note: The maximum total current of the decoder is 700 mA.
Function mapping according to RCN-227
Assigning the functions to the outputs follows RailCommunity standard
RCN-227. It is possible to assign one or several outputs to each
function (F0 to F28, seperately for forward and backward motion for
each function). In addition, it is possible to assign another function as
an "OFF"-switch to the functions.
English
Page 11