SD-34 | SD-34.2
7.4. Connection examples
8. Programming the decoder
You can program the configuration variables (CV) using a DCC digital
central unit. See the chapter in the manual of your central unit where
the byte wise programming of configuration variables (CVs) is
explained.
When using a Motorola central unit you can set the decoder address
with a programming jumper (SD-34) or with a programming
button (SD-34.2). Changing the other decoder´s features or assigning a
locomotive address is neither necessary in layouts run in Motorola
format only nor possible with Motorola central units.
English
Connection of a
signal to terminals
4 to 6 ("switching
contacts 4")
push-
Page 25