Table of Contents
Advertisement
English
Programming the locomotive decoder
The locomotive decoder is programmed from the digtial central. See
chapter in the manual of your digital control unit where the
programming of configuration variables (CVs) is explained.
You can programm resp. read out the following locomotive decoder
variables:
NB. With central units with register-programming it is only possible to
program the variables CV#1 to CV#4 (= register 1 to 4) and CV#29 (=
register 5).
2
*
Tip: You program the configuration variables CV#29, CV#39 to 41,
CV# 49, CV#55 to 57 and CV#60 to 62 by entering the sum of the
numerical values which are assigned to the desired parameters.
CV-name
Basic
address
Starting
voltage
Acceleration
rate
Page 36
CV-
Input value
no.
(State of
delivery)
1
1 ... 127
(3)
2
0 ... 255
(10)
3
0 ... 255
(16)
Remarks
= The voltage to be output to the
motor at speed level 1.
The value "0" corresponds to 0
Volt, the value "255" to the max.
voltage.
= Length of the delay before the
switching to the next higher
speed level when the locomotive
is accelerating.
The delay is calculated as follows:
(value of CV#3) x 0,9 sec. /
number of speed levels
LD-G-5
Advertisement
Table of Contents
