tams elektronik FD-R Basic.3 Manual page 50

English
Problems with switching via the switching input

After passing a permanent magnet in the rails no action is activated.
Possible cause: The reed contact or the Hall sensor has been
mounted incorrectly. → Check the connections.
Possible cause: The distance to the magnet is too large or the
magnet is too weak. → Alter the position of the magnet (if possible)
or use a stronger one.
Possible cause: The magnet has been mounted incorrectly polarized.
→ Alter the mounting direction.
Possible cause: The assignment of the function to the switching
input is wrong or the minimum switch-on time is too short. → Check
the inputs in CV 62 and 97.
Problems in analogue mode

The decoder does not react in analogue mode.
Possible cause: The analogue mode is switched off. → Alter the value
for CV 29.

The decoder does not switch to analogue mode (or switches over
although it is still digitally controlled).
Possible cause: The value in CV 11 is set too high or too low. → Alter
the value and check the settings in operation.
Page 50
FD-R Basic.3