Table of Contents
Advertisement
English
6.4. Connecting inductive loads
When connecting inductive loads (e.g. TELEX couplings, relays or other
accessories with coils), you should switch a free-wheeling diode (e.g.
1N400x) in parallel, in order to avoid damage at the output. Check to
connect the anode of the diode to the function output.
Connecting accessories via a relay
When you want to switch an accessory / accessories via the decoder,
which connection would lead to exceeding the maximum current at the
output or of the decoder, you can switch the accessories via a relay
(e.g. 1xUm 1A 12V, item-number84-61010) and connect them directly
to the vehicle´s current collector.
The current consumed by the relay depends on its type. The relay
named in the example needs approx. 100 mA.
As described in the section "Connecting inductive loads" you should
switch a free-wheeling diode (e.g. 1N400x) in parallel to the relay.
Page 22
FD-R Basic.3
Fig. 2: Connection
of an accessory via
a relay
Advertisement
Table of Contents
