tams elektronik FD-R Basic.3 Manual page 28

English
Put the vehicle on a track oval or a track section connected to the central
unit's track output (not to the connection for the programming track).
Make sure no other vehicle than the one you intend to program is set on
the track as the decoder inside this vehicle might be programmed as well.
Starting
the programming mode
1. Switch on the central unit or
perform a reset at the central
unit (pushing "stop" and "go")
simultaneously.
2. Set the current decoder
address (default value: 3) or the
address "80".
3. Set all functions to "off".
4. Push button "stop"
→ switch off the track voltage.
5. Operate the direction switch
and hold it in that position.
Push the button "go" at once.
6. As soon as the lighting
flashes, release
the direction switch.
→ Programming mode
Programming with the Central Station I and the Mobile Station
With the Central Station I or the Mobile Station of Märklin** you can
program the registers. Select the article number 29750 from the
locomotive database and program the decoder as described for this
article in the Central Station´s or Mobile Station´s manual.
Page 28
Programming the decoder
1. Enter the number of the
register as a Motorola-address.
If necessary: with a leading "0".
2. Operate the direction switch.
→ Lighting flashes faster.
3. Enter the value you want to
set into the register
(as Motorola-address).
4. Operate the direction switch.
→ Lighting flashes more slowly.
If necessary: repeat steps 1 to 4
for all registers to be
programmed.
Push button "stop".
→ End of programming mode
FD-R Basic.3