Programming The Locomotive Decoder - tams elektronik LD-G-24 Manual

English

Programming the locomotive decoder

The locomotive decoder is programmed from the digtial central. See
the chapter in the manual of your digital control unit where the
programming of configuration variables (CVs) is explained.
You can programm resp. read out the following locomotive decoder
variables:
NB. With central units with register-programming it is only possible to
program the variables CV#1 to CV#4 (= register 1 to 4) and CV#29 (=
register 5).
CV-name
Basic
address
Starting
voltage
Acceleration
rate
Braking
rate
Page 40
CV-
Input value /
no.
(State of
delivery)
1 1 ... 127
(3)
2 0 ... 255
(5)
3 0 ... 255
(8)
4 0 ... 255
(5)
Remarks
= The voltage to be output to the
motor at speed level 1.
The value "0" corresponds to 0
Volt, the value "255" to the max.
voltage.
= Length of the delay before the
switching to the next higher
speed level when the locomotive
is accelerating.
The delay is calculated as follows:
(value of CV#3) x 0,9 sec. /
number of speed levels
= Length of the delay before the
switching to the next lower speed
level when the locomotive is
braking. The delay is calculated
as described in CV#3.
LD-G-24