Table of Contents
Advertisement
Network error, standard port [54]
Try one or more of the following:
•
From the printer control panel, press
•
Unplug the router, wait for 30 seconds, and then plug it back again.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or the print server.
Paper too short [34]
Try one or more of the following:
•
Load the correct size of paper in the tray.
•
From the printer control panel, press
•
Check the tray length and width guides and make sure the paper is loaded properly in the tray.
•
Make sure the correct paper size and type are specified in Print Properties or in the Print dialog.
•
Make sure the paper size and type settings are specified in the Paper menu on the printer control
panel.
•
Make sure the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, then
make sure the paper is large enough for the data being printed.
•
Cancel the print job.
Parallel port disabled [56]
Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the parallel port.
•
From the printer control panel, set Parallel Buffer to Auto.
Printer restart. Check last job.
Press
on the printer control panel to clear the message and continue printing.
User's Guide
to clear the message and continue printing.
to clear the message and print using a different tray.
to clear the message and continue printing.
- 143 -
Advertisement
Table of Contents
