Table of Contents
Advertisement
Use
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Timeouts
Wait Timeout
Disabled
15–65535
User's Guide
To
Set the amount of time the printer waits before it enters
Hibernate mode.
Note: 3 days is the factory default setting.
Set the printer to Hibernate mode even if there is an active
Ethernet connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds before returning the control
panel to a Ready state.
Note: 30 is the factory default setting.
Set the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the rest of the job.
Notes:
•
90 is the factory default setting.
•
When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see if
any new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print
jobs.
Set the amount of time in seconds the printer waits for
additional data before canceling a print job.
Note: 40 is the factory default setting.
- 100 -
Advertisement
Table of Contents
