Table of Contents
Advertisement
Ti interface
Approved ESD precautions must be followed at all times during readhead and interface electrical connection.
The readhead is connected to the Ti interface via a small, rugged interboard connector to allow for easy feed-through during installation.
Connecting the readhead
1. Remove the cover plate as shown (two M2.5 hex head screws).
2. Taking care not to touch the pins, plug the connector into the socket in the interface, ensuring correct orientation as shown.
3. Refit the cover plate, ensuring the cable ferrule is located in the recess on the inside, and no wires are trapped under the cover plate.
NOTE: The tightening torque should be between 0.25 Nm and 0.4 Nm.
4. Proceed with
'Readhead mounting and alignment'
on page
37
and
'System calibration'
on page 45.
www.renishaw.com
35
Advertisement
Table of Contents
