Table of Contents
Advertisement
RTLF mounting
(for lengths < 500 mm only)
1. Thoroughly clean and degrease the substrate using recommended solvents (see
'Storage and handling'
on page 8). Allow substrate to dry before applying scale.
3. Locate scale against dowels or ledge and
1
rotate down onto substrate.
4. Clean scale using Renishaw scale wipes or a clean, dry, lint-free cloth.
1
If dowels or ledge are permanent, their maximum height above substrate is 0.6 mm.
2. Remove backing paper from scale.
Support
dowels
5. Fit datum clamp and end covers (page 19) and, if needed, deselect reference
marks that are not required as detailed (page 21).
6. Remove temporary dowels (if fitted).
or
Location ledge
www.renishaw.com
15
Advertisement
Table of Contents
