Table of Contents
Advertisement
RCLC mounting
Suitable for:
RCLC glass spar scale, any length.
Required parts:
•
RCLC scale (see
'RCLC installation drawing'
•
RGG-2 two part epoxy adhesive (A-9531-0342)
•
Appropriate cleaning solvents (see
'Storage and handling'
Optional parts:
•
Renishaw scale wipes (A-9523-4040)
•
Lint-free cloth
1. Thoroughly clean and degrease the substrate using recommended solvents
(see
'Storage and handling'
on page 8). Allow substrate to dry before
applying scale.
2. Remove backing paper from scale.
on page 22)
on page 8)
3. Ensure correct orientation of the scale for chosen reference mark location (middle or end of scale)
and readhead orientation. See
'RCLC installation drawing'
4. Locate scale against dowels or ledge and rotate down onto the substrate.
Support dowels
Location ledge
1
If dowels or ledge are permanent, their maximum height above substrate is 1.2 mm.
on page
22
for details.
1
or
www.renishaw.com
23
Advertisement
Table of Contents
