NEC Express5800/320Fa-L User Manual page 397

2.
Set a dual LAN configuration.
Refer to the page 3-23 for the dual configuration of the network.
Now the 1000BASE-T 1ch board set, 1000BASE-SX 1ch board set, or 1000BASE-T 2ch board
set is installed.
N8803-032 SCSI Board
The lists of slots to install optional PCI boards
Refer to "List of option PCI boards and installable slots:" on page 8-36.
Driver installation procedure
TIPS:
To perform this procedure, you have to log on the system as an Administrator or a member of the
Administrators group.
1.
Mount a N8803-032 SCSI board in one CPU/IO module. Then, connect the power cord of that
CPU/IO module, power on the server, and start the system.
2.
Set the "NEC EXPRESSBUILDER" CD-ROM into the CD-ROM drive, and run
UPDATE.VBS located at CD-ROM_drive:\HAS\W2K3\HASSETUP\SCSI_folder.
If the pop-up window for confirming to overwrite a file appear, click [Yes] and continue the
installation.
3.
After one minute, remove the CD-ROM and shut down the server.
4.
Mount a N8803-032 SCSI board into the other CPU/IO module. (Skip this step if unnecessary.)
5.
Connect the power cable of the CPU/IO module you mounted the SCSI board in 4, power on
the server, and confirm that the dual configuration of the SCSI boards are set when the system
starts up.
6.
Set the "NEC EXPRESSBUILDER" CD-ROM into the CD-ROM drive, and run
UPDATE.VBS located at CD-ROM_drive:\HAS\W2K3\HASSETUP\SCSI_folder again.
7.
After one minute, remove the CD-ROM and reboot the server.
Now the driver is applied.
System Upgrade 8-41