NEC Express5800/320Fa-L User Manual page 134

4-20 System Configuration
Server
Move the cursor onto [Server] to display the Server menu.
The following describes options you can configure in the Server menu and their functions.
Select an option with the "►" mark and press Enter to display its submenu.
Refer to the table below for information on options.
Option
Thermal
[Disabled]
Sensor
Enabled
BMC IRQ Disabled
[IRQ 11]
Post Error [Disabled]
Pause
Enabled
AC LINK Stay Off
[Last State]
Power On
Power ON [0]-255
Delay Time
* "Console Redirection" is shown only when the N8815-001/001A ft Remote Management Card is
installed. (Installed in standard for 320Fa-M and 320Fa-MR models)
Parameter
Enable or disable the thermal sensor
functions.
Set the IRQ of BMC interruption.
Set whether or not to pause POST at the end
of POST if an error has occurred during
POST execution.
Specify the AC LINK feature by selecting the
status of the power supply unit of the server
when the AC power supply restarts. (See the
table on the next page for details.)
Configure the DC ON delay time if AC LINK
is set to "Power On" or "Last State" (unit:
second).
Description
[ ]: Factory-set