Installing Cpu/Io Module - NEC Express5800/320Fa-L User Manual

8-16 System Upgrade

Installing CPU/IO Module

Follow the procedure below to install the CPU/IO module:
The 320Fa-L model is used in the example quoted here. However steps you should take are the same
for other models.
IMPORTANT:
Make sure to read "ANTI-STATIC MEASURES" (page 8-3) and "PREPARING YOUR
SYSTEM FOR UPGRADE" (page 8-4) before starting installing or removing options.
1.
Firmly hold the CP/IOU module with both hands and insert it into the rack.
Hold the CPU/IO module in such a way that its back panel connector faces the back of the rack
and engage the guides of the
module and chassis, and insert it
slowly.
2.
Hold the handle to push the
module as far as it goes.
3.
Put the handle back in the position where it was.
The installed CPU/IO module will start
automatically.
IMPORTANT:
Connect the cables that you disconnected
before removing the CPU/IO module to
where they were originally connected.
Connect cables while the handle is leaned
toward you.
4.
Secure the handle with the screws.
IMPORTANT:
Secure the handle with the screws. If it is not secured by the screws, the CPU/IO will
not be powered on.
In some system statuses or settings, auto start up or integration does not take place
when the module is connected. In such a case, check the status by using the Server
Maintenance Utility or NEC ESMPRO Manager data viewer, and then power on by the
module POWER switch or start up the IO and CPU modules.
After installing CPU/IO module, always power on the module using the power switch.
Handle