NEC Express5800/320Fa-L User Manual page 284

5-84 Installing and Using Utilities
BMC Firmware Update
The firmware of the BMC on the PCI module can be updated.
The base management controller (BMC) is the processor exclusively used for monitoring the
system's operating environment faults and controlling of the system.
The BMC firmware can be updated by using the BMC firmware update utility.
Both NEC ESMPRO Manager and the Server Maintenance Utility can start the BMC firmware
update utility.
To update the BMC firmware, the firmware image file must be updated on the managed server in
advance. On the BMC firmware update screen, specify the path of the image file of the firmware to
be updated.
The table below shows the potential cases in which the BMC firmware is to be updated.
IMPORTANT:
Contact your maintenance personnel for the update of the BMC firmware.
Component
BMC When an update to new firmware is
required.
Executable in the following module
state (this can be viewed on
manager screen):
Remote: Executable from remote management PC by using NEC ESMPRO Manager
Local: Executable on local server by using Server Maintenance Utility
–: Not support
Remote
Duplex
BMC firmware update
When an update to new firmware is
required.
Executable in the following module state
(this can be viewed on Server Maintenance
Utility screen）
Duplex
Local