Power On - NEC Express5800/320Fa-L User Manual

Power ON

To power on NEC Express5800/ft series, press the POWER switch located on the right of the front
panel.
Follow the steps below to turn on the power.
1.
Power on the display unit and other peripheral devices connected to the server.
CHECK:
If the power cord is connected to a power controller like a UPS, make sure that it is
powered on.
2.
Press the power switch located on the right of the front panel.
The POWER LED illuminates in green. After
a while, the "NEC" logo will appear on the
screen.
IMPORTANT:
When you connect a power cord to an AC
inlet, wait ten or more seconds to press the
POWER switch.
Do not turn off the power before you see
the "NEC" logo and a character below the
logo. It may take one to five minutes for
the logo to appear depending on you server
configuration.
While the "NEC" logo is displayed on the screen, NEC Express5800/ft series is
performing a power-on self test (POST) to check itself. For details, see "POST Check"
described later in this chapter. Upon the completion of POST, Windows Server 2003 will
start.
CHECK:
If the server finds errors during POST, it will interrupt POST and display the error
message. See Chapter 7.
General Description 2-33