NEC Express5800/320Fa-L User Manual page 331

Unavailable disks are displayed on Disk Management:
Follow the instruction below:
Disk Status
DISK ACCESS LED is amber and blinking:
Is the mirror of the hard disk not removed?
→ Check [Disk Management], and reconfigure the mirror if the mirror is broken.
(See "Configuring and Breaking Mirror" in Chapter 3 "Windows Setup and
Operation.")
Relevant Disk LED and DISK ACCESS LED illuminate amber during the process
of automatic mirror reconfiguration. During the process of reconfiguration, DISK
ACCESS occurs at the same time, and amber and green appear to illuminate
alternately. Wait for a while if it is found out that the mirror is being reconfigured
in "Disk Management", etc.
When one of the disks that configure the mirror is broken, the other disk becomes
"Failed Redundancy." In this case, DISK LED also illuminates amber. Replace the
failed disk and reconfigure the mirror.
CPU load ratio of SNMP Service (snmp.exe) increases:
→ While monitoring the server from NEC ESMPRO Manager, the CPU load ratio of
SNMP Service on the NEC ESMPRO Agent side may increase at every monitoring
interval (default: 1 minute).
→ NEC ESMPRO Manager and NEC ESMPRO Agent exchange information through
SNMP Service. If the server status monitoring by NEC ESMPRO Manager is on
Description
A message [Foreign] is
displayed when the dynamic
disk used on another system is
mounted.
A message [Missing] is
displayed when the dynamic
disk is broken or removed.
A message
[Not Initialized] is displayed
when there is no signature on
the disk.
Troubleshooting 7-25
Action
[To use data of the disk]
Import the disk referring to Chapter 3
"Windows Setup and Operation."
[To make the disk usable]
Initialization is required to use this
disk. Initialize this disk to convert it to
a usable disk.
<Note>
The data on disks are lost when
initialized. Make sure to back up the
data before initializing disks.
Delete the mirror on the disk when
mirror volume is on missing disk.
After deleting the mirror, right-click
[Missing] disk and execute [Remove
disk].
Right-click on the disk and execute
[Initialize Disk] to convert it to a usable
disk.