NEC Express5800/320Fa-L User Manual page 330

7-24 Troubleshooting
Source:
Type:
Event ID:
Description: Since removal of each device was not completed, the driver was not
IO module is not disconnected:
→ When you attempt to disconnect IO module while network adapter and/or SCSI
adapter and/or FC adapter is not in dual mode, the following message will be
recorded to the system event log and the IO module will not be separated. In this
case, check each adapter setting referring to "After starting up, FT Status LED do
not illuminate or illuminate amber" of this chapter.
Source:
Type:
Event ID:
Description: Device [Device name] is not duplexing.
→ When you attempt to disconnect IO module when the HAS Fault Tolerance service
is not started, the following message will be recorded to the system event log and
the IO module will not be separated. In this case, refer to "After starting up, FT
Status LED do not illuminate or illuminate amber" of this chapter to start the HAS
Fault Tolerance service and retry disconnecting the I/O module.
Source:
Type:
Event ID:
Description: The doubleness information about an I/O device is not reported.
HasCtrl
Information
1408
able to bind the CPU/IO module. [Module[Module Number]]
[Module Number] "#0" or "#1"
HasCtrl
Warning
1505
[Device name] "LAN" or "SCSI" or "FC"
HasCtrl
Warning
1506