Table of Contents
Advertisement
VERS.2022.10.20
6 MAINTENANCE AND SERVICE
ATTENTION: to perform maintenance on the machine, always switch it off. Always wear a face
mask and safety goggles while performing the maintenance of machine.
6.1 Maintenance of the machine
To ensure a long-term quality from the cutting with the CS1-500, please follow the maintenance
plan below:
Whole machine
Flange and blade fixing devices
Belts tension
Water hoses and nozzles
Depth screw
Engine housing
Reachable nuts and screws
Adjustment and replacement of the belts
After one hour of work, the belts heat and stretch. Therefore, you have to re-tension them.
To adjust the belts, firstly remove the belt guard by unscrewing the 2 nuts. Loose the 2 bolts at
the back of the engine-plate and shift the engine by using the screw on the back of the plate to
retighten the belts.
To replace the belts, move the engine completely down by unscrewing the screw at the back of
the engine-plate. Adjust the belts and retighten them using the screw at the back of the engine
plate.
Always use a matched set of belts. Do not replace single belts. After controlling or retightening
the belts, reassemble the belt guard on the frame of the machine.
Lubrication
The CS1-500 uses life-lubricated bearings. Therefore, you don't need to lubricate them at all.
Grease the depth screw every day.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work.
Regular service period
Perform at every indicated period
Visual
control
(general
watertightness)
Clean
Clean
Control
Clean
Grease
Clean
Tighten up
CS1-500_MAN_EN
aspect,
19
Advertisement
Table of Contents
