Load Project Via Usb Port; Connection - Pilz PNOZmulti Mini Operating Manual

Commissioning
6.2.3.2

Load project via USB port

Procedure:
} Insert a chip card into the card slot on the base unit.
}
Connect the computer containing the PNOZmulti Configurator to the base unit via the
USB port.
}
Switch on the supply voltage.
}
Download the project (see PNOZmulti Configurator's online help).
}
Once the project has been successfully downloaded, the status of the inputs and out-
puts and the supply voltage will be shown via the LEDs. The "RUN" LED is lit.
6.2.4

Connection

Supply voltage
For the safety system
For the semiconductor outputs
Must always be present, even if
the semiconductor outputs are not
used
Input circuit
E-STOP
without detection of shorts across
contacts
E-STOP
with detection of shorts across
contacts
Start circuit
Operating Manual PNOZ mm0p-T
1002704-EN-02
AC
Single-channel
S1
IM0
S1
IM0
T0M20
Input circuit without detection of
shorts across contacts
I5
DC
A1
A2
24 V
0 V
Dual-channel
L+
T1M21
T0M20
Input circuit with detection of
shorts across contacts
S3
L+
T0M20
+ 24 V DC
0 V
+ 24 V DC
0 V
S1
L+
IM0
L+
IM1
S1
IM0
IM1
S3
I5
19