Table of Contents
Advertisement
Inner Glass Panel (Firebox Glass) Installation / Removal
• Glass panels must be installed to operate the fireplace.
WARNING: GLASS HANDLING
We recommend using the glass vacuum holders supplied by the
manufacturer. Lower the glass to rest in a safe place to prevent
damage to the glass edges. Extra care must be taken when removing/
installing the glass; breakage or damage to the edge of the glass
which occurs as a result of careless handling is not covered under
warranty.
• We recommend handling the glass with supplied vacuum clamps.
• When removing glass, prepare a soft, scratch resistant
surface to place the 60-1/4" (1530 mm) x 19-13/16" (504 mm)
glass.
• Never clean or remove hot glass.
Note: The suction cups may leave a round film on the glass when
used. Ensure that the glass is cleaned using a fireplace glass cleaner
after each removal and prior to operating the appliance.
1. Remove outer safety barrier glass panels if previously installed–see instruc-
tions in this manual.
2. Remove outer panels installed in unit - see panel removal section in this manual.
Press glass vacuum clamps in open position firmly onto surface of glass.
Bring handles together to close.
Open
Handle glass with supplied vacuum clamps
The following installation diagrams do not include the vacuum
clamps but it is strongly recommended to use clamps at all times
when handling the firebox glass.
Closed
Glass removal video
installation-panels, barriers, faceplates
3. From the front inside lower panel of the unit--pivot the 3 glass supports
into upright position as shown below.
Glass supports in upright position
4. Open the 8 clamps at the top of the glass.
3RD ANGLE
PROJECTION
DIMENSIONS
0.000 = 0.01 CRITICAL
0.000 = SPECIFIED TOLERANCE
DO NOT SCALE
0.000 = 0.031
DRAWING
0.000 REF = REFERENCE ONLY
UNITS IN INCHES
ANGULAR = 1
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY W
With the top clamps in open position, use your hands to pull the
DO NOT SCALE
two glass gasket rails towards you.
UNITS IN INCHES
Clamps in closed position
TOLERANCES UNLESS
FIREPLACE PRODUCTS
OTHERWISE STATED
INTERNATIONAL
1:24
SCALE:
MEDRALIN
DWN:
E.C.N.:
3RD ANGLE
TOLERANCES UNLESS
FIREPLACE PRODUCTS
PROJECTION
OTHERWISE STATED
INTERNATIONAL
DIMENSIONS
0.000 = 0.01 CRITICAL
1:24
SCALE:
0.000 = SPECIFIED TOLERANCE
0.000 = 0.031
DRAWING
MEDRALIN
DWN:
0.000 REF = REFERENCE ONLY
ANGULAR = 1
E.C.N.:
SIGN:
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT OUR PRIOR WRITTEN CONSENT.
Clamps in open position, rail pulled
forward
City Series CP60E |
-
MAT'L :
SHEAR/
PROCESS :
CP60 MAIN
PART :
11/23/2021
PART N
DATE:
457
DATE:
SIGN:
-
MAT'L :
SHEAR/ PUNCH/ FORM
PROCESS :
CP60 MAIN ASSEMBLY
PART :
11/23/2021
PART NO:
REV:
DATE:
457-500
-
DATE:
77
Advertisement
Table of Contents
