Wall Mount On / Off Switch And Battery Holder Installation - Regency Fireplace Products City CP60E Series Owners & Installation Manual

page of 116

/ 116
Contents
Table of Contents
Bookmarks

Table of Contents

Wall Mount On / Off Switch and Battery Holder Installation

Required for all installations

IMPORTANT: The battery holder must be placed inside the supplied (low voltage)

junction type wall box and installed into the wall only.

DO NOT INSTALL WITHIN THE CONFINES OF THE FIREPLACE

SWITCH MUST BE ACCESSIBLE

Battery Holder Installation

1. Install the low-voltage junction box on the framing, at desired location within 12-1/2 ft. (3.8 m) of the fireplace.

2. Feed the 6 pin connector wiring harness through the opening at the back of the junction box. The wiring harness is located on the right side and must

be installed prior to finishing.

3. Connect the 6 pin connector to the back of the battery holder.

4. Install the battery holder in the low-voltage junction box.

5. On the non-power vent model only:

4 AA batteries should not be installed into the battery holder/switch box if 120 AC volt electrical

connections are made to the receptacle. Only Install 4 AA batteries during power outages to run the main burner or if 120 volt power was never brought

to appliance. 120 Volt AC power is also required to operate the lights.

On the power vent model only:

Do not install 4 x AA batteries as this appliance will only operate using 120 volt AC power.

6. Place the slider into the cover plate.

7. Put the battery holder switch in the "OFF" position to allow correct lineup for slider switch.

8. Make sure the battery holder and cover plate words "ON" and "UP" are on the same side.

9. Align the slider with the switch on the battery holder and couple the switch into the slider.

10. Align the screw holes.

11. Using the two (2) screws provided, secure the cover plate to the battery holder.

12. For coding instructions, see full details in this manual.

Proflame Battery Holder

REMOTE