Table of Contents
Advertisement
Optional Enamel Panels
Before installation, panels must be handled and cleaned as per instructions noted below:
•
Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for dam-
age after installation will not receive consideration.
•
Black Enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
*
All hand and finger marks MUST be cleaned off with a soft cloth.
prints before applying heat to the unit.
Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.
1. Remove Faceplate, Safety Screen if already installed.
2. Undo the bottom 2 door latches and open and remove glass door
Remove logs.
Note: The logs must not be in the unit.
3.
Insert the back enamel panel first by carefully placing it between
the back wall of the firebox and the rear log bracket.
NOTE: the folds of the back panel should be facing inward toward the
burner.
4.
Install the side panel pushing it toward the back- when in position
the side panel should cover the flange on the back panel. Be very
careful not to scratch them on the firebox hardware.
919-641
OPTIONAL ENAMEL PANELS
Black Enamel Panels
Use an ammonia based cleaner (ie. glass cleaner) to remove any finger-
1
P36D / P36DE/ P36E
5. When panel is in position—secure with a panel clip, secured with
one screw, repeat on other side to install opposite panel.
Panel clip
Completed install
Regency
P33E-11 Zero Clearance Direct Vent Gas Fireplace
®
installation
|
03.01.21
45
|
45
Advertisement
Table of Contents
