Table of Contents
Advertisement
Horizontal Terminations - Flex Vent 5" x 8" (127 mm x 203 mm) (Non Power Vent)
These venting systems, in combination with the CP60E Direct Vent Gas Fireplace, are tested and listed as a direct vent heater system by Intertek. The location
of the termination cap must conform to the requirements in the vent terminal locations diagram in the "Exterior Vent Termination Locations" section of this
manual.
Regency
Direct Vent (Flex) System Termination Kits include all the parts needed to install the CP60E using a flexible vent.
®
FPI Kit #
Length Contains:
1)
#946-615
4 Feet
2)
3)
4)
#946-618
6 Feet
5)
6)
7)
#946-616
10 Feet
8)
9)
10) Vinyl Siding Standoff
• Liner sections should be continuous without any joints or seams.
• Only flex pipe purchased from Regency® may be used for flex
installations.
• Horizontal vent must be supported every 3 feet.
• Regency® Direct Vent System (Flex) is only approved for horizontal
terminations.
• Flex system can only be used up to a maximum continuous vent
length of 10 feet. If longer runs are required, rigid pipe must be used.
8" Flexible Liner (Kit length)
5" Flexible Liner (Kit length)
Spring Spacers
Thimble
AstroCap XL Termination Cap
Screws
Tube of Mill Pac
Plated Screws
S.S. Screws #8 x 1-1/2" Drill Point
5
20
installation
Vent Guard - if required*
(Part #946-506/P)
City Series CP60E |
55
Advertisement
Table of Contents
