Table of Contents
Advertisement
Maintenance Instructions
1. Always turn off the gas valve before cleaning.
For relighting, refer to lighting instructions. Keep
the burner and control compartment clean by
brushing and vacuuming it at least once a year.
When cleaning the logs, use a soft, clean paint
brush as the logs are fragile and easily damaged.
2. Clean appliance and door with a damp cloth
(never when the unit is hot). Never use an
abrasive cleaner. The glass should be cleaned
with a gas fireplace glass cleaner. The glass
should be cleaned when it starts
looking cloudy.
3. The fireplace is finished in a heat-resistant paint
and should only be refinished with heat-resistant
paint. Regency
uses StoveBright Paint - Metallic
®
Black #6309.
4. Periodically check the burner for proper
positioning and condition. Visually check the
flame of the burner periodically, making sure
the flames are steady, not lifting or floating.
If there is a problem, call a qualified service
person.
5. The appliance and venting system must be
inspected before use and at least annually by
a qualified field service person, to ensure that
the flow of combustion and ventilation air is not
obstructed.
6. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and replace
any part of the control system and gas control
which has been under water.
7. In the event this appliance has been
serviced, check that the vent-air system was
resealed & reinstalled in accordance with the
manufacturer's instructions.
8. Verify operation after servicing.
General Vent Maintenance
Conduct an inspection of the venting system
semiannually. Recommended inspection areas are
listed below.
1. Check the venting system for corrosion in areas
that are exposed to the elements. These will
appear as rust spots or streaks, and in extreme
cases, holes. These components should be
replaced immediately.
2. Remove the cap and shine a flashlight down the
vent. Remove any bird nests or other foreign
material.
3. Check for evidence of excessive condensation,
such as water droplets forming in the inner
liner and dripping out the joints. Continuous
condensation can cause corrosion of caps,
pipes, and fittings. It may be caused by having
excessive lateral runs, too many elbows, and
exterior portions of the system exposed to cold
weather.
4. Inspect joints to verify that no pipe sections
or fittings were disturbed or loosened. Also
check mechanical supports such as wall straps
or plumbers' tape for rigidity.
Log Replacement
The appliance should never be used with broken
logs. Turn off the gas valve and allow the unit to cool
before opening the door and removing the logs. If
a log needs replacement, you must use the proper
replacement log. The position of these logs must
be as shown in the diagrams under log installation.
Glass
Improper positioning of logs may create
carbon buildup and will alter the appliance's
performance. The resulting damage is not
covered under warranty.
Your Regency
fireplace is supplied with high
®
temperature 5mm tempered outer glass & 5mm
ceramic inner glass. If your glass requires cleaning,
we recommend using an approved glass cleaner
sold by an authorized dealer. Do not use abrasive
materials or ammonia-based cleaners.
Glass Replacement
• Do not clean the glass when it
is hot.
• The use of substitute glass will
void all product warranties.
• Do not strike the glass.
• Do not operate this fireplace with
a cracked, broken, or missing
glass front.
Wear gloves and safety glasses
•
when removing damaged or bro-
ken glass.
• Replacement of glass panels
should be done by a licensed or
qualified service person.
In the event that you break your glass by impact,
purchase your replacement from an authorized
Regency dealer only. Replacement glass is shipped
already installed into the door frame. Reinstall
as per the instructions in the "Glass Installation"
section.
Replacement Glass Part
Numbers
Outer Safety Glass Side - Tempered
(Part# 940-545/P Side B, 940-546/P Side A)
Outer Safety Glass End - Tempered
(Part# 940-544/P)
Inner Glass Side (Part# 940-542/P)
Inner Glass End (Part# 940-543/P)
owner's information
City Series CP60E |
17
Advertisement
Table of Contents
