Table of Contents
Advertisement
installation
Enamel/Steel Panel Installation (Steel Panels - Part # 761-907, Enamel Panels - Part # 761-908)
G800
For Black Enamel Panels:
• Black enamel panels must be inspected for scratches and dimples
prior to installation. All claims are to be recorded at this time. Claims
for damage after installation will not receive consideration.
• Black enamel panels will discolor a little during normal operation.
This is normal and should not be considered a defect.
* All hand and fingerprints MUST be cleaned off with a soft cloth.
Use an ammonia-based cleaner (ie. glass cleaner) to remove any
fingerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which
you will be unable to remove. Not protected by product
warranty.
Note: Do not install the firebed grate, media, vermiculite, embers,
and logs until the enamel/steel panels are installed.
1. Remove screen and glass door, if installed.
2. Loosen two screws in locations shown below. Slide upper baffle
towards the back wall and then remove from unit.
3. Loosen 2 screws on pilot assembly in locations shown below. Slide
pilot shield towards the back of the unit and remove from unit.
4. Install back panel carefully. Tilt panel forward from the top and
rest the bottom of the panel on the firebox floor. Tip top back until
it also rests on the firebox back wall.
5. Loosen screws and remove brick clips.
1
2
Item
Part #
Description
1
N/A
Inside Top of
Firebox
2
N/A
Panel
3
761-049
Brick Clip
4
904-519
Screw
920-128b
68
| Grandview
G800EH Gas Fireplace
®
3
4
ENAMEL/STEEL PANEL INSTALLATION
6. Install the right side panel—the angled corner should be located
facing the bottom rear of the fireplace when installing.
NOTE: Shorter row of bricks should be positioned at the bottom of
back and side panels.
7. With panel in position, secure it with the brick clip removed in Step
5 and retighten the screw.
8. Repeat Steps 5-7 on the left side.
9. Slide the bottom panel carefully underneath the burner and
push to the back until it contacts the back panel.
10. Reinstall the upper baffle.
11. Reinstall the pilot shield removed in step 3.
1
09.29.22
Advertisement
Table of Contents
