Table of Contents
Advertisement
CAUTIONS
1. Utilize all standard electrical safety precautions when using this or any other electrical
equipment.
2. Always use this system in a well-ventilated area. A fume extraction system such as those
available from PACE are highly recommended to protect personnel from solder flux
fumes.
5. Exercise proper precautions when using chemicals (e.g., solder paste). Refer to the
Material Safety Data Sheet (MSDS) supplied with each chemical and adhere to all safety
precautions recommended by the manufacturer.
Servicing Precautions
DANGERS
POTENTIAL SHOCK HAZARD - Repair procedures performed on this product should be
performed by qualified service personnel only. Line voltage parts will be exposed when
equipment is disassembled. Service personnel must avoid contact with these parts when
troubleshooting.
Precautions
The following are general safety precautions that personnel must understand and follow when
using or servicing this product. These precautions may or may not be included elsewhere in this
manual.
Safety
Electrical Requirements
The MBT 350 unit draws approximately 240 VA (240Watts), which is listed on the nameplate
on the power source rear panel. A separate, dedicated AC supply line circuit may be required
to adequately power the unit/system. If your power outlet cannot provide suitable power,
arrange for a qualified, licensed electrician to install one for you.
System Set-Up
Power Source
Set up the MBT 350 system using the following steps and associated drawings.
1. Remove the MBT 350 from its shipping container(s). Store the shipping container(s) in a
convenient location. Reuse of these containers will prevent damage if you ship or store
the system.
2. Set the MBT 350 unit on a convenient workbench.
3. Place the POWER Switch (on power source front panel) in the "OFF"
or "0" position.
©2005 PACE Inc., Annapolis Junction, Maryland All Rights Reserved
Page 9 of 19
Advertisement
Table of Contents
