System Power Up; Set Up Mode - Pace SODRTEK ST 325 Operation And Maintenance Manual

Timed Mode: Mode of operation in which the operator enters the Operating Temperature, Cycle Time,
vacuum operation and Blower Speed parameters. When the reflow cycle is initiated, the system will
operate as per those parameters and turn off at the end of the cycle time. The operator manually
performs any other required procedures (e.g., vacuum operation, preheat) of the rework operation.
Vacuum Release Time: Time delay from the start of a Reflow cycle (in Program Mode, Install only) until
vacuum terminates to release component.
V-A-N Nozzle: Vented Air Nozzle.

System Power Up

1. Insert the female end of the power cord into the AC Power Receptacle on the rear panel of
the power source.
2. Plug the prong end (male end) of the power cord into an appropriate 3 wire grounded AC
supply receptacle.
CAUTION: To insure operator and ESD/EOS safety, the AC power supply receptacle must be
checked for proper grounding before initial operation.

Set Up Mode

The set up mode provides the option to select from the following items:
1. Password Entry
2. Temperature scale selection (° C or ° F)
3. Auto Vac
4. Deletion of profiles
1. Turn Power Switch Off.
2. Turn the ST 325 On while holding the Menu Button. Release the Menu Button when the LCD
displays the Development Date (e.g., "Dev 4/06/04"). The LCD will now display "Password
Needed?" if there is no password currently stored in the system. If a password is stored, the LCD
will display "Enter Password" and "Password = 0000." Notice that the question mark is no longer
present.
3. If there is no Password stored and you would like to create one, press the Scroll Up Button (
for yes and go to step 5. If there is no Password stored and you do not want to create one, press
the Scroll Down Button ( ) or the Select Button for no and go to step 6.
4. If there is a Password stored, use the Scroll Keys (
NOTE: If an incorrect password is entered, the system will display "Wrong Password" and exit
out of the Set Up Mode.
5. Enter the Password using the Scroll Keys (
NOTE: Please copy the chosen password and keep in a safe place.
6. Press the Select Button after the password is selected. The LCD will now display the desired
temperature scale (e.g., "Display is ° F?").
©2013 PACE Inc., Southern Pines, NC
All Rights Reserved
) to select the stored password.
).
)
Page 11 of 31