Drives; Media - Spectra Logic Spectra 12000 User Manual

Remote library controller

Hide thumbs Also See for Spectra 12000:

Table of Contents

Remote Library Controller User Guide

Network Address Use this section to Set IP Addresses:

Select DHCP if your network provides IP addresses through DHCP.

When you are finished, select Set Network Config.

Select Use Static IP if you want to assign an IP address, and type in

the addresses you would like to use. When you are finished, select

Set Network Config.

Caution: Spectra Logic strongly recommends selecting Use

Static IP to ensure accessibility to your library.

Note: The Library Control Module (LCM) will reboot after

setting a new network configuration and RLC will be off

line until the LCM comes up at the new address. This

process may take up to a minute to complete.

Date and Time Use this section to set the date and time of the library. When

you are finished setting the date and time, select Set Time.

Drives

To review the drive status, see Drives on page 31.

To review the media status, see Inventory on page 20.

Table of Contents

Do you have a question about the Spectra 12000 and is the answer not in the manual?

Spectra 64000