Controller; Configuring S-Qips And L-Qips - Spectra Logic Spectra 12000 User Manual

Note: The drive's SCSI ID must be unique from the QIP
bus, other drives on the QIP bus and any device on the
host bus it is attached to.
You cannot set the SCSI ID for a drive on a Fibre Channel
QIP.
The following are only necessary in special circumstances. Refer to the
Preparing the Server document located on the Spectra Logic Web site at
www.spectralogic.com, to see if you need to set drive switch settings or
drive emulation for your operating system.
Switches Use the Switches section to turn on or off the drive switches.
Caution: Do not change the drive switches manually unless
directed by a Spectra Logic Technical Support
representative to do so.
If you think you need to set drive switches manually, call
Spectra Logic Technical Support at (800) 227-4637 for
help.
Bus Mode Use Bus Mode to modify the drive's bus mode.
Caution: Do not change Bus Mode unless instructed to do
so by Spectra Logic Technical Support.

Controller

Configuring S-QIPs and L-QIPs

The RLC allows the user to configure SCSI controllers
(S-QIPs and L-QIPs).
To configure S-QIPs and L-QIPs:
1. From the RLC, select the Configuration toolbar.
Chapter 3. Configuration 33