Spectra Logic Spectra 12000 Install Manual
Fan assembly
Hide thumbs
Also See for Spectra 12000:
- User manual (190 pages) ,
- Supplementary manual (47 pages) ,
- Install manual (19 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Chapters
Table of Contents
Related Manuals for Spectra Logic Spectra 12000
Summary of Contents for Spectra Logic Spectra 12000
-
Page 1: Fan Assembly
Spectra 12000 Fan Assembly ™ Replacement Guide P.N. 90910856 Revision B... - Page 2 Information furnished in this manual is believed to be accurate and reliable. However, no responsibility is assumed by Spectra Logic for its use. Due to continuing research and development, Spectra Logic may revise this publication from time to time without notice, and reserves the right to change any product specification at any time without notice.
- Page 3 Contents Introduction ... 4 Remove the Old Fan Assembly ... 7 Install the New Fan Assembly...8 Finish...9 Spectra 12000 Fan Assembly Replacement Guide 3...
-
Page 4: Introduction
About Gator architecture Both the Spectra 12000 library and Spectra 64000 library utilize the Gator architecture for robotic tape libraries developed by Spectra Logic. Gator architecture in the Spectra 12000 library can be configured with 60 or 120 cartridges and from two to eight tape drives. Gator architecture in the Spectra 64000 library can be configured with up to 640 cartridges and 32 tape drives in a single rack. -
Page 5: What You Will Need
How long will this take? This procedure should take less than 15 minutes. What you will need A Spectra 12000 Fan Assembly Replacement Kit, P.N. 90919004 A #2 Phillips screwdriver Introduction Spectra 12000 Fan Assembly Replacement Guide 5... -
Page 6: Prepare The Library
Prepare the Library The Spectra 12000 fan assembly is a hot swappable part. You can replace the fan assembly without disabling the backup software or disconnecting the power. Make sure you have four feet of clearance at the back of the library. -
Page 7: Remove The Old Fan Assembly
Remove the Old Fan Assembly 1. Go to the back panel of the Spectra 12000 library. Use the #2 Phillips screwdriver to loosen the two captive screws (Figure 3). Captive screws Figure 3 Loosen the captive screws. 2. Pull the fan assembly out by the handle (Figure 4). -
Page 8: Install The New Fan Assembly
3. Push the new fan assembly into place. 4. Use the #2 Phillips screwdriver to tighten the two captive screws (Figure 6). Captive screws Figure 6 Tighten the captive screws. Spectra 12000 Fan Assembly Replacement Guide Figure 5 Align new fan assembly and push into place. -
Page 9: Finish
Figure 7 Fans: Warning message. You have completed the fan assembly replacement procedure. If you have difficulty If you need further assistance with any part of these procedures, call Spectra Logic Technical Support at (800) 227-4637 or (303) 449-6444, extension 3175. Finish...