Assembling The Handle - Hayter CODE543A Operator's Manual

Assembling the Handle

Parts needed for this procedure:
1. Upper handle assembly
2. Bolt
3. Locknut
Procedure
Important: Remove and discard any plastic or
wrapping on the machine.
Note: Remove the rubber end-cap from the handle
assembly prior to inserting the upper handle bar
into the lower handle bar. This was added during
manufacturing to prevent damage to the cables.
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling
and unfolding the Handle.
• If a cable is damaged, contact a Hayter
Authorised Service Dealer.
1. Install the upper handle assembly to the lower
handle and secure it using 2 bolts and 2 locknuts
as shown in Figure 3.
2. Pull the handlebar release brace toward the
upper handle to release the handle lock. Figure
4.
©2021 - Toro U.K. Limited
Spellbrook, Bishop's Stortford,
Hertfordshire, CM23 4BU
Figure 3
3. Lift the handle into the operating position and let
go of the handlebar release brace. Figure 4.
Note: Ensure that the handle clicks into place.
11
Figure 4
Printed in UK
All Rights Reserved