Cleaning The Machine; Cleaning The Grass Box; Folding The Handle - Hayter CODE543A Operator's Manual

5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator light Indicates
Off No battery pack inserted
Green blinking Battery pack is charging
Green Battery pack is charged
Red Battery pack and/or battery charger
is over or under the appropriate
temperature range
Red blinking Battery pack charging fault*
*Refer to Troubleshooting for more information.
Important: The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage.

Cleaning the Machine

Service Interval: After each use or daily.
WARNING
Remove safety key and battery prior to cleaning
the machine. Wear gloves and eye protection when
servicing the machine.
WARNING
To prevent damage to the motor, do not use water
to clean the machine - Dry clean only.
For best results, clean under the machine soon after
you have completed mowing.
1. Shut off the machine, remove the battery pack
and the safety key.
2. Lower the machine to its lowest cutting-height
setting.
3. Set the machine in the vertical-stow position;
refer to Storing the Machine in the Vertical-Stow
Position.
4. Using a brush or broom, clean any debris away
from the underside of the machine.
Important: Do not use water to clean the
machine; water
components.
©2021 - Toro U.K. Limited
Spellbrook, Bishop's Stortford,
Hertfordshire, CM23 4BU
may damage electrical

Cleaning the Grass Box

Service Interval: After each use or daily.
Frequently clean the grass box to ensure maximum
collection capability. Brush away any debris.

Folding the Handle

WARNING
Folding or unfolding the Handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the Handle.
• If a cable is damaged, contact an Authorised
Service Dealer.
WARNING
Ensure the handle is in the operating position prior
to starting the machine to prevent thrown object
related injuries.
1. Shut off the machine, remove the safety key,
and the battery pack. Refer to Shutting Off the
Machine.
2. Pull the handlebar release brace toward the
upper handle to release the handle lock. Figure
18.
3. Fold the handle halfway forward to the upright
position, or fully forward to the vertical-stow
position as shown in Figure 19.
21
Printed in UK
All Rights Reserved