Adjusting The Cutting Height; Cutting Height Positions - Hayter CODE543A Operator's Manual

Adjusting the Cutting Height

WARNING
Adjusting the height-of-cut could bring your hands into contact with a moving blade and result in serious
injury.
• Shut off the motor, remove the safety key and battery pack, and wait for all movement to stop
before adjusting the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
To adjust the cutting height, press down on the height-of-cut button and raise or lower the deck until the
desired height-of-cut setting is shown in the height-of-cut indicator window. Figure 8.
1.

Cutting Height Positions

Height of cut is adjustable in 6 increments between 19mm (3/4") and 70mm (2-3/4").
©2021 - Toro U.K. Limited
Spellbrook, Bishop's Stortford,
Hertfordshire, CM23 4BU
Height-of-cut button
Indicator
1
2
Figure 8
2. Height-of-cut indicator window
Height of Cut Position
1
Set to this position when putting the
mower into the vertical-stow position.
2
3
4
5
6
15
Printed in UK
All Rights Reserved