Table of Contents
Advertisement
Setup
Note: The battery pack is not fully charged when it
is purchased. Before using the machine for the fi rst
time, refer to Charging the Battery Pack.
Mounting the Battery Charger
(Optional)
Parts needed for this procedure:
1.
Mounting hardware (not included)
If desired, mount the battery charger securely on a
wall using the wall-mount key holes on the back of
the charger.
Mount it indoors (such as a garage or other dry
place), near a power outlet, and out of the reach of
children.
Refer to Figure 2 for assistance in mounting the
charger.
Slide the charger over the appropriately positioned
hardware to secure the charger in place (hardware
not included).
Assembling the Handle
No Parts Required
1. Attach the lower handle to the mower housing
with 4 bolts, 4 fl at washers, 4 split washers, and
4 nuts (Figure 3).
©2020 - Hayter Limited
Spellbrook, Bishop's Stortford,
Herts, CM23 4BU
101.6 mm
4 in
Figure 2
1.
Bolt (4)
2.
Flat washer (4)
2. Attach the upper handle to the lower handle
using 2 handle knobs, 2 curved washers, and
2 bolts. Tighten the handle knobs securely by
hand (Figure 4).
1
2
1.
Handle knob (2)
2.
Curved washer (2)
3.
Bolt (2)
10
1
3
2
4
Figure 3
3.
Split washer (4)
4.
Nut (4)
4
3
5
Figure 4
4.
Upper handle
5.
Lower handle
Printed in China
All Rights Reserved
Advertisement
Table of Contents
