Table of Contents
Advertisement
Maintenance
Remove the safety key and battery pack from
the machine before maintaining or cleaning the
machine.
Use
only
the
manufacturer's
replacement parts and accessories.
Inspect and maintain the machine regularly. Have
the machine repaired only by an Authorised Service
Dealer.
Lubricating the Machine
You do not need to lubricate the machine; all the
bearings have been lubricated at the factory for the
life of the machine.
Replacing the Blade
Service Interval: Yearly
Important: You will need a torque wrench to install
the blade properly.
If you do not have a torque wrench or are
uncomfortable performing this procedure, contact
an Authorised Service Dealer.
If the blade is damaged or cracked, replace it
immediately. If the blade edge is dull or nicked, have
it sharpened and balanced, or replace it.
WARNING
When servicing the blade, be aware that the blade
can still move even though the power source is off.
The blade is sharp; contacting the blade can result
in serious personal injury.
Wear gloves when servicing the blade.
1. Remove the safety key and battery pack from
the machine.
2. Use a block of wood to hold the blade steady.
Figure 23.
©2021 - Toro U.K. Limited
Spellbrook, Bishop's Stortford,
Hertfordshire, CM23 4BU
recommended
3. Remove the blade, saving all mounting hardware
4. Install the new blade, washer, and blade bolt.
Important: Position the curved ends of the blade to
point toward the machine housing.
5. Use a torque wrench to tighten the blade bolt to
23
Figure 23
Figure 24.
Figure 24.
Figure 24
35 N∙m (26 ft-lb).
Printed in UK
All Rights Reserved
Advertisement
Table of Contents
