Related Manuals for Hayter CODE377A
Summary of Contents for Hayter CODE377A
- Page 1 Operator’s Manual 41cm Lawn mower Model No. CODE377A - Serial No. 407600000 and Up Original Instructions (EN) Form No. 3441-216 Rev B...
- Page 2 THIS PAGE HAS BEEN LEFT INTENTIONALLY BLANK...
-
Page 3: Table Of Contents
- Rear Deflector ............... 15 - Shutting off the Machine ..........15 - Removing the Battery Pack ..........15 - Setting the Power-Boost / Boost Max Modes ....15 ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU... - Page 4 - Prepare the Battery for Recycling ........20 - Storage ................21 Troubleshooting ..............22 - 23 Warranty ................24 Privacy Policy ..............25 Blank Page ................26 - 28 ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved...
-
Page 5: Introduction
1. Keep bystanders, especially children and pets, out of the operating area. CODE377A does not include a battery or a charger. These are available to purchase from your local 2. Do not operate the machine without all guards Hayter sales dealer. -
Page 6: Operation
8. Remove the battery pack and electric-start button from the machine whenever you leave it unattended or before changing accessories. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 7: Maintenance And Storage
7. Check the grass collection bag frequently for deterioration or wear, and replace a worn bag with a Hayter replacement bag. 8. For best performance, use only genuine Hayter replacement parts and accessories. Other replacement parts and accessories could be dangerous, and such use could void the product warranty. -
Page 8: Safety And Instructional Decals
Blade Control Bar - Engage Power-Boost / Boost-Max Variable Speed Control Electric-Start Button Power Control Blade Control Bar - Disengage Printed on control Printed on electric-starter ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... - Page 9 The battery pack is charging. The battery pack is over or under the appropriate temperature range. The battery pack is fully charged. Battery pack charging fault. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved...
-
Page 10: Setup
Check that the following items have been supplied correctly. Grass Bag Assembly Parts List Declaration of Conformity Electric-Start Button If any items are missing, contact your supplying Hayter dealer. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 11: Assembling The Handle
Ensure that the cables are routed so that they do not become snagged in the handle. • If a cable is damaged, contact a Hayter Authorised Service Dealer. 1. Unscrew the hand bolts sufficiently to allow the handle to pivot (1). Hold the motor stop lever in... -
Page 12: Product Overview
Parts List for consumable and replacement parts. These documents are supplied separately, with this Operator Manual, refer to Delivery Checklist. If either are missing, contact your supplying Hayter dealer or visit www.hayter.co.uk for information. Appropriate Temperature Ranges Charge/store the battery 5°C (41°F) to 40°C (104°F)*... -
Page 13: Operation
To change the cutting height, hold the lever and pull it sideways to disengage it from the locking notch. • Pull the lever backwards to raise the cutting ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU... -
Page 14: During Operation
Figure 15 Ground speed may be adjusted by operating the variable speed control (2). Push forward to speed up and pull back to slow down. Figure 14. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU... -
Page 15: Removing The Grass Bag
Figure 17. 3. Remove the battery pack; refer to Removing the Battery Pack from the Machine. Figure 18 AUTO speed MAX speed Figure 17 ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 16: Operating Tips
• For best performance, install a new blade before the cutting season begins. • Replace the blade when necessary with a Hayter replacement blade. Figure 18 Cutting Grass Vari-Pitch™ Cutting Cut only about a third of the grass blade at a time. -
Page 17: After Operation
8. Shut off the motor. Battery-charge- Charger venting areas indicator button 9. Shut off the water and disconnect the hose from the machine. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 18: Folding The Handle
11. Shut off the motor and allow it to cool before the machine. storing the machine in an enclosed area. Use only Hayter recommended replacement parts Folding the Handle and accessories. WARNING: Folding or unfolding the handle Inspect and maintain the machine regularly. -
Page 19: Blade Sharpening
Inspect the blade for signs of damage. Sharpen both cutting edges with a flat file to restore performance. Figure 25. 30° Figure 28 Figure 25 ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 20: Adjusting The Self-Propel Lever
If the blade does not stop within 3 seconds or there is a grinding or scraping, metal-to-metal noise when you release the motor stop lever, contact a Hayter Authorised Service Dealer. Figure 29... -
Page 21: Storage
• To reduce the risk of serious personal injury, do not store the battery pack outside or in vehicles. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... -
Page 22: Troubleshooting
2. The battery pack is weak. 2. Properly dispose of the battery pack at a battery recycling facility. ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved... - Page 23 4. Grass bag full. 4. Empty grass bag. Blade drive will not engage/ 1. Motor stop lever not fully forward 1. Push fully forward to disengage disengage ©2020 - Hayter Limited Spellbrook, Bishop’s Stortford, Printed in UK Herts, CM23 4BU All Rights Reserved...
-
Page 24: Warranty
3 year period - Residential Use Only). To qualify for the 5 year warranty, you must have the machine serviced by a Hayter Authorised Service Dealer* within 12, 24, 36 and 48 months of the date of purchase. -
Page 25: Privacy Policy
To do so, please contact us by email at legal@toro.com. If you have concerns about the way in which Hayter Ltd has handled your information, we encourage you to raise this directly with us. Please note that European residents have the right to complain to your Data Protection Authority. -
Page 26: Blank Page
THIS PAGE HAS BEEN LEFT INTENTIONALLY BLANK... - Page 27 THIS PAGE HAS BEEN LEFT INTENTIONALLY BLANK...
- Page 28 THIS PAGE HAS BEEN LEFT INTENTIONALLY BLANK...
Need help?
Do you have a question about the CODE377A and is the answer not in the manual?
Questions and answers