NEC Bull NovaScale R620 User Manual page 58

To remove the CD-ROM, press the CD-tray-eject button as you did in setting the
CD-ROM.
When the access LED lights orange, it indicates the CD-ROM is being accessed. Make
sure the access LED is not illuminating in orange before you press the CD-tray-eject
button.
Press the locking part in the centre of the tray and pick the CD-ROM gently. When you have removed the CD-ROM,
push the tray to the drive-closed position.
IMPORTANT:
When you click the "Safely Remove Hardware" icon on the task-tray, device names such as "USB Mass Storage
Device" are displayed. Never attempt to remove devices other than "USB Floppy drive". If the removal operation is
done, system performance is not guaranteed.
If you did removal operation of these devices by mistake, click "Safely Remove Hardware" icon again and select
"Safely remove AMD PCI to USB Open Host Controller". The removed device will be then recognized again.
When you cannot eject a CD-ROM
When you cannot eject the CD-ROM from the server even by pressing the eject button, follow the steps below to eject
it:
1.
Press the POWER switch to power off this server (i.e. the POWER/SLEEP LED is off).
2.
Use a metal pin of about 1.2 mm in diameter and 100 mm long (alternatively,
you can use a fairly large paper clip after straightening). Insert it gently into the
manual release hole located at the low front side of the server until the tray is
ejected.
IMPORTANT:
Do not use a toothpick, plastic pin, or other breakable objects.
If you cannot eject the CD-ROM by following the steps above, contact your sales agent.
3.
Hold the tray and pull it out.
4.
Take out the CD-ROM.
5.
Push the tray back.
NovaScale R620 User Guide
2-30