Setting Device Control Parameters (Set); Reset To Factory Settings; Showing And Deleting The History Memory; Querying Software Version (Inf) - Bender ISOMETER isoES425 Manual

4.7

Setting device control parameters (SEt)

Open menu "SEt" to configure the device control.
Display Activation
FAC
off
nEt on
S.Ct on
FAC
SYS
FAC Factory settings
Cs Customer settings
4.8

Reset to factory settings

All settings with the exception of the interface parameters are reset to the factory settings.
1. Press MENU button (> 1.5 s).
2. Go to "SEt" and confirm with Enter.
3. Go to "FAC" and confirm with Enter.
4.9

Showing and deleting the history memory

ADVICE
The history memory saves the measured values for the first fault only. To this end, the history
memory must be empty.
Show history memory
Call up "HiS" menu and go up or down.
Delete history memory
Call up "HiS" menu, go to "Clr" and confirm.
4.10

Querying software version (InF)

The software version is displayed as a ticker. Afterwards it can be output step by step using the up or down
buttons.
How to proceed
1. Press MENU button (> 1.5 s).
2. Go to "InF" and confirm with Enter.
3. If necessary, use up or down buttons to display it step by step.
Setting value
Cs Range FAC
0. . .999
Cs
0 Password for parameter setting
System connection test
Device test at device start
Restore factory settings
For Bender Service only
isoES425_D00214_01_M_XXEN/10.2023
ISOMETER® isoES425
Description
25